色悠悠久久综合亚洲|日本一区二区不卡视频|国产午夜精品理论片在线|精品少妇无码av无码专区|国产成人亚洲精品变态另类|亚洲高清精品一区二区三区|无码精品人妻一区二区三区涩|中文字幕Aⅴ无码一区二区三区

Welcome To Visit Wuxi Xuelang Electronic Solder Factory!

Wuxi Xuelang Electronic Solder Factory

Wuxi xuelang feng electronics co., LTD

HotLine:
0510-85180426

?

News

Position:Home > News

新聞資訊

0510-85180426 HotLine

Contact

Addr:28-38 Nanhu Middle Road, Xuelang Street, Binhu District, Wuxi City, Jiangsu Province#

Tel:0510-85180426

Fax:0510-85187742

Contact:Mr Gen 13506182816

Contact:Mr Zhou 13771441499

Email:xldzhlc@126.com

Basic Requirements for Lead-free Electronic Solder for Electronic Assembly (Part III)

2019-05-16354

Basic Requirements for Lead-free Electronic Solder for Electronic Assembly (Part III)

It has good solderability under the condition of existing equipment and non-cleaning flux. The electronic solder should have sufficient humidity and can be used with conventional non-cleaning flux. Because the cost of inert treatment of wave crest is not too high, it can accept the requirement of wave crest welding plus inert environment. But for SMT reflow welding, it is better for alloy to have the ability of reflow welding in air, because the cost of inert treatment of reflow furnace is higher.

Good physical properties (strength, tensile strength, fatigue, etc.) electronic solders must be able to provide mechanical strength and reliability that 63Sn/37Pb can achieve, and there will be no protruding fillet welds on through-hole devices (especially for alloys with large temperature range of solid-liquid coexistence).

Production repeatability/melting point consistency, electronic assembly process is a mass manufacturing process, requiring a high level of repeatability and consistency. If the composition of some electronic solders can not be re-manufactured in large batches, or the melting point of some electronic solders can not be considered because of changes in composition during mass production. The electronic solder composed of more than three components will often be separated or changed, which makes the melting point unstable. The higher the complexity of the alloy, the greater the possibility of its change.


prev:Analysis of Technological Properties and Influencing Factors of Electronic Solder (Part I)         next:Basic Requirements for Lead-free Electronic Solder for Electronic Assembly (Part 2)

Hotline:0510-85180426

Email:xldzhlc@126.com

Address:Wuxi Xuelang Electronic Solder Factory

WapWap